try to put some strategic lines on the surface and use
Line{num_line} In Surface{num_surface}
to force the mesh trough them
Le Fri, 9 May 2014 17:12:41 +0200,
Hugo BORIE <[email protected]> a écrit :
> That's what I did but the mesh is not as expected. It didn't give me a
> "grid" around the square hole.
> Le 9 mai 2014 16:30, "jean pierre aubry" <[email protected]> a
> écrit :
>
> > what about Recombine Surface {sums}
> >
> >
> > Le Fri, 9 May 2014 16:23:05 +0200,
> > Hugo BORIE <[email protected]> a écrit :
> >
> > > I've seen this message but I tried without the "Transfinite
> > > Surface". But I want to obtain a quadrangle not a triangle mesh
> > > and possibly structured so I don't see any solution without using
> > > the transfinite function?
> > >
> > >
> > > On Fri, May 9, 2014 at 1:45 PM, jean pierre aubry
> > > <[email protected]>wrote:
> > >
> > > > hello
> > > >
> > > > the msg in the message console of Gmsh is clear enough
> > > >
> > > > Error : Surface 1 is transfinite but has 1 holes
> > > >
> > > > --
> > > > jean pierre aubry
> > > > 33 688 670 795
> > > >
> > > > _______________________________________________
> > > > gmsh mailing list
> > > > [email protected]
> > > > http://www.geuz.org/mailman/listinfo/gmsh
> > > >
> >
> >
> >
> > --
> > jean pierre aubry
> > 33 688 670 795
> >
--
jean pierre aubry
33 688 670 795
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
