Hi,
Your lines have length 1, while the characteristic length of the mesh
you defined was 10.
What happens if you set lc = 1?
With only one line embedded it works fine for me (and
RandomFactor=1e-8), but I didn't try for all 50K of them.
Best,
Mikhail
On 01/15/2015 02:29 AM, [email protected] wrote:
Hi,
I have encountered the issue "*Identical points in triangulation: increase
element size or Mesh.RandomFactor*" in my 2D geometry file. After looking
into previous support mails, I changed the Mesh.RandomFactor to 1e-8, 1e-7
until 1e-2. However, it still fails. Could you tell me what other option I
should try since I am pretty new to Gmsh?
My geometry is simple. I have a surface with size 1100 by 210. Also, there
are 50K lines with length 1 embedded in that surface.
Thanks for your help in advance!
Best,
YC
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
