Dear all,
I have a problem with intersecting surfaces. I have a fairly complicated
geometry, using a lot of ruled surfaces, and I would like to inspect where the
intersecting happens.
Error : Self intersecting surface mesh, computing intersections (this could
take a while)Info : 5 intersecting faces have been saved into
'intersect.pos'Error : Could not open file 'intersect.pos'
However, there is no 'intersect.pos' file, as can also be seen from the error
message. If I run from command line I do not get this error, but in that case
I'm not sure how to inspect visually where the problem occurs.
Kind regards,
Taco Broerse
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
