[EMAIL PROTECTED] wrote:
sorry to ask again, I hope this is my last question about this.
since I know now that the restarted run I did started from 0 time. I
killed the job and it wrote velocity for the last frame. So since i knew i
have to contiune this run that I just killed, I used tpbconj and it wrote
a new tpr file and it said it will restart it from the time I killed the
job ( half the simulation). SO i think I am set now to continue the
simulation this way.
The first time you used it, it will also have told you the frame it was
going to be able to start from. The output messages are usually very
thorough and helpful. Read them carefully and think about what they
mean! :-)
Thank you. I will save some energies and velocities in future simulations.
but in this email, my job was not crashed..I terminated it and it wrote
the last velocities and when i wanted to contiune it using pbdconj, it
said it will finish the simulation from the time I terminated it.
so is this accurate enough to finish it?
Maybe. To get an exact continuation of some runs with temperature and/or
pressure coupling you need to supply an .edr file. If you don't give one
and it wanted one, tpbconv will warn you.
Had you read the man page to tpbconv closely before using it, you would
have been aware of these issues already. It describes why you had all of
the problems that you had. You would have saved yourself and the mailing
list some time :-) Please make a habit of searching manuals, man pages
and mailing list archives before asking.
Mark
_______________________________________________
gmx-users mailing list [email protected]
http://www.gromacs.org/mailman/listinfo/gmx-users
Please search the archive at http://www.gromacs.org/search before posting!
Please don't post (un)subscribe requests to the list. Use the
www interface or send it to [EMAIL PROTECTED]
Can't post? Read http://www.gromacs.org/mailing_lists/users.php
