Dear users, I performed NPT simulations of few different systems using both gromacs v3.2.1 and v3.3.1. I use exactly the same parameters, starting files, topology files etc for both the versions. The systems are pure water system (10684 water molecules) and a protein-water system. However, the average volume of the system that I get is from the simulations is different for the two versions. In case of pure water, gromacs v3.2.1 gives me a lower volume (~311.497 nm^3) than v3.3.1 (~324.604 nm^3) and the difference is significantly higher than the fluctuations in the volume. The pressure is maintained at 1 bar and the temperature is maintained at 300 K using Berendsen barostat and thermostat respectively. I was wondering if someone could tell me why this happens? Has there been a modification in the pressure virial calculation or something related to the same that leads to these differences?
Thank you Regards Sapna -- Sapna Sarupria Ph.D. Student - Chemical Engineering Rensselaer Polytechnic Institute Troy, New York 12180 U.S.A. Ph#: (518)276-3031 Life isn't about finding yourself. Life is about creating yourself. George Bernard Shaw. Dare to Dream
_______________________________________________ gmx-users mailing list gmx-users@gromacs.org http://www.gromacs.org/mailman/listinfo/gmx-users Please search the archive at http://www.gromacs.org/search before posting! Please don't post (un)subscribe requests to the list. Use the www interface or send it to [EMAIL PROTECTED] Can't post? Read http://www.gromacs.org/mailing_lists/users.php