thank you all the same. I saw many people use Amber for REMD and few
people use Gromacs for REMD and the parameters is not easy reachable.
However, what I found is that Amber use cutoff=999
I am just wondering, shall I also use such big value for the following?
rlist = 999; short-range neighborlist cutoff (in nm)
rcoulomb = 999 ; short-range electrostatic cutoff (in nm)
rvdw = 999 ; short-range van der Waals cutoff (in nm)
thank you very much
Albert
On 10/17/2012 06:18 PM, saber naderi wrote:
I am no expert in implicit solvent simulations but I think for these
simulations it is better to use stochastic dynamic integrators with no
pbc (instead of NVT) and infinite (or very large) cut-off distances because
there is no actual water molecule in your simulation box and [normally] you
do not have to worry about the boundary effects.
For finding appropriate parameters, you should have a look at the Gromacs
manual and read the literature but if you need a quick example see below
(please note that this is just an example).
Cheers,
Saber
--
gmx-users mailing list [email protected]
http://lists.gromacs.org/mailman/listinfo/gmx-users
* Please search the archive at
http://www.gromacs.org/Support/Mailing_Lists/Search before posting!
* Please don't post (un)subscribe requests to the list. Use the
www interface or send it to [email protected].
* Can't post? Read http://www.gromacs.org/Support/Mailing_Lists
