Greetings,

I have a Dell 2300 running RH 6.2 that's been happily going a couple years 
running apple's quicktime streaming server software.

Its set up with raid 5 w/parity on the three drives using hardware raid via 
megaraid v107. I added a 4th drive and found a utility called MegaMgr on 
the web and added the 4th physical drive to the logical drive then 
reconstructed the raid and judging by disk light activity the 
reconstruction worked and it is writing to all 4 drives in the array. 
However, df doesn't reflect any difference in avail storage. My other 
PowerEdge servers all have perc2 and I haven't found any useful docs on the 
megaraid, I am at a loss at how to make the os see the actual new size of 
the logical drive, Is anyone familiar with the megaraid and the megamgr 
util? I must be missing some step to make the os see that the logical drive 
grew by 36gig? any suggestions appreciated!!

dmesg snippit follows:

...
megaraid: v107 (December 22, 1999)
megaraid: found 0x8086:0x1960:idx 0:bus 2:slot 10:func 1
scsi2 : Found a MegaRAID controller at 0xd0034000, IRQ: 18
megaraid: [3.00:1.36] detected 1 logical drives
scsi2 : AMI MegaRAID 3.00 254 commands 16 targs 1 chans 8 luns
scsi : 3 hosts.
scsi2: scanning channel 1 for devices.
  Vendor: DELL      Model: 1x6 U2W SCSI BP   Rev: 5.23
  Type:   Processor                          ANSI SCSI revision: 02
scsi2: scanning virtual channel for logical drives.
  Vendor: MegaRAID  Model: LD0 RAID5 25704R  Rev: 3.00
  Type:   Direct-Access                      ANSI SCSI revision: 02
Detected scsi disk sda at scsi2, channel 1, id 0, lun 0
SCSI device sda: hdwr sector= 512 bytes. Sectors= 52641792 [25704 MB] [25.7 
GB]
 sda: sda1 sda2 < sda5 sda6 sda7 sda8 sda9 sda10 >
autodetecting RAID arrays
autorun ...
... autorun DONE.

Thanks!!
-joe


---------------------------
[EMAIL PROTECTED]
(603) 646-0387
---------------------------

**********************************************************
To unsubscribe from this list, send mail to
[EMAIL PROTECTED] with the following text in the
*body* (*not* the subject line) of the letter:
unsubscribe gnhlug
**********************************************************

Reply via email to