Clicking the column doesn't mass change transactions.
I'd say you are either viewing an opposing register in basic mode, or
you did something else entirely to produce that result.
Figuring that out is likely the best bet.
Otherwise, just do a new reconciliation and mass-select them all. That
should only take a few clicks.
Regards,
Adrien
On 3/23/26 4:25 PM, Mark at Lorimark wrote:
So, looking at one of my registers, I see a few hundred transactions up
a reconciliation 'Y' is now a 'N'... I must have accidentality clicked
on the column and cleared the reconciliation.
How can I get the 'Y' reapplied without having to go through all the
reconciliation steps all over again?
_______________________________________________
gnucash-user mailing list
[email protected]
To update your subscription preferences or to unsubscribe:
https://lists.gnucash.org/mailman/listinfo/gnucash-user
-----
Please remember to CC this list on all your replies.
You can do this by using Reply-To-List or Reply-All.
