Hello Marcus, Thank you for sharing your open-source code. Since I wasn't certain which email address is currently active, I've sent this message to all the addresses I found.
I'm seeking assistance with using gphoto2 to stream a live view from a Nikon D7500 to a Raspberry Pi. My goal is to facilitate this stream through a WebSocket server. Previously, I had a functioning setup using digicamcontrol, but I later discovered that using a Raspberry Pi would be more suitable for this project. I'm interested in employing a method similar to the one used in digicamcontrol, rather than resorting to movie capture stdout. From my understanding, based on the Maid3d1 file, it's necessary to change the LiveViewStatus to 1 to enable live viewing. However, I've encountered a challenge: the Live View Status setting is returning "Readonly: 1". Despite attempting to set the control mode to 0 first, the issue persists. Here are the details of the setting I'm struggling with: /main/other/d1a2 Label: Live View Status Readonly: 1 Type: MENU Current: 0 Choice: 0 0 Choice: 1 1 Could you possibly offer some guidance or point me in the right direction to resolve this issue? Met vriendelijke groet, Kind regards, Glenn van der Werff [https://hardwarecare.nl/wp-content/uploads/2022/09/Hardware_logo.gif] Middelweg 37 5253 CE Nieuwkuijk The Netherlands T +31 (0) 858 769 800 www.hardwarecare.nl<http://www.hardwarecare.nl>
_______________________________________________ Gphoto-devel mailing list Gphoto-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/gphoto-devel
