Thank you for answer. After 'exit' command no message is displayed and machine stops responding.
I did additional tests yesterday trying to boot different machines with this card. On the machine with an old revision S5000PSL (with builtin VGA) (the one I was describing in previous email): if I didn't press ctrl+B there was a "Press F2 to enter SETUP" message displayed and sometimes after pressing F2 it was changing into "Entering SETUP", but nothing happened. On the machine with a newer revision S5000PSL (with builtin VGA), after not pressing ctrl+B in gpxe there was initialization message of second chipset on my NC380T (which I didn't turn off) displayed, something like "Press F1 to skip iSCSI". And then "Press F2 to enter SETUP".... On the third machine with an old recision S5000VSA (with PCI VGA card and builtin VGA card disabled): If I pressed ctrl+B machine was immediately rebooted. If I didn't there was "press F2 to enter setup" and machine was rebooted after few seconds. On all the machines I've tried enabling and disabling Intel Embedded RAID and it didn't change anything. I'm planning to buy Intel PRO/1000 ET NIC, put it in lower number PCI-e port, boot OS from iSCSI, disable mba on both chipsets on NC380T and then continue to solve first issue, but this time probably running gPXE from USB stick. Marcin Kosieradzki >> Another issue is that I am now unable to enter computer BIOS or boot >> any OS - I will need to reflash my NIC, but AFAIK I cannot do this >> without network connectivity. > > Does the "exit" gPXE shell command fail? What happens? > > Stefan > _______________________________________________ gPXE mailing list [email protected] http://etherboot.org/mailman/listinfo/gpxe
