Hi,

I installed WINGRASS 63 RC6 and tried again v.rast.stats. Before running it I chose a small region (only a bit more than 2 polygons). The following error messages were printed:

:/GRASS/scripts/v.rast.stats: v.db.addcol: command not found
DBMI-DBF driver error:
Column 'qb4_reg1_n' not found
Error in db_execute_immediate()


Error while executing: 'UPDATE kacheladdstat SET qb4_reg1_n=1020 WHERE cat=24495'

Statistics calculated from raster map <[EMAIL PROTECTED]> and uploaded to attribute table of vector map <kacheladdstat>.

Done.

The dbf file of the vector has not been altered.

Regards

Niels


Marco Pasetti schrieb:
Hi Moritz,

Moritz, does it probably has been fixed in RC6?

Niels, could you download and install WinGRASS-6.3.0RC6 (before uninstall
RC5 using Add/Remove programs utility) and check if v.rast.stats works in
it?

Thanks

Marco

-----Messaggio originale-----
Da: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] Per conto di Moritz Lennert
Inviato: martedì 8 aprile 2008 23.03
A: [EMAIL PROTECTED]
Cc: [email protected]; GRASS devel; Hamish
Oggetto: [GRASS-dev] Re: [GRASS-user] trouble with v.rast.stats
underWINGRASS

On 08/04/08 18:04, Niels Thevs wrote:

Dear GRASS users,

I am using WINGRASS 6.3 (RC5) and tried the command v.rast.stats. But I encountered the error messages below, though the vector and raster are in the same mapset.

[EMAIL PROTECTED] is not in the current mapset (PERMANENT)

An error occurred while converting vector to raster
G__open(r): mapset (PERMANENT) doesn't match xmapset (PERMANENT_3280.0) G__open(r): mapset (PERMANENT) doesn't match xmapset (PERMANENT_3280.0)

[EMAIL PROTECTED] is not in the current mapset (PERMANENT)

Does anybody know, how to overcome this problem ?


This was fixed by Hamish here http://trac.osgeo.org/grass/changeset/30136

but apparently it did not get backported.

A quick fix for you is to click on the command in the Output window, so that
you can edit it at the bottom and change the

[EMAIL PROTECTED]

into

vector=split1

and then push 'Run'.

A more permanent fix is to download the current version of the script from
here:

http://trac.osgeo.org/grass/browser/grass/trunk/scripts/v.rast.stats/v.rast.
stats

and replace you $GISBASE/scripts/v.rast.stats

with the downloaded file.


Moritz
_______________________________________________
grass-dev mailing list
[EMAIL PROTECTED]
http://lists.osgeo.org/mailman/listinfo/grass-dev



--



-----------------------------------------------------
Dr. Niels Thevs
Chair of Geobotany and Landscape Ecology
Institute of Botany and Landscape Ecology
Greifswald University
Grimmer Strasse 88
17487 Greifswald
Germany

Tel.: +49-3834-86-4137
Fax:  +49-3834-86-4114

-----------------------------------------------------


_______________________________________________
grass-user mailing list
[email protected]
http://lists.osgeo.org/mailman/listinfo/grass-user

Reply via email to