Hi! Try "map" instead of "m...@permanent" in command i.target.
I've also experienced this problem. If I didn't specify the mapset informations in the map names, it works. So try write just "state" instead of "st...@permanent" and "map" instead of "m...@petmanent" everywhere. This helps for me, though I use the gui for i.group and i.target. Regards, Istvan csütörtök 30 április 2009 dátummal Joe Bayles ezt írta: > I'm not even really there yet. I've followed the following steps: > Created an undefined XY location for importing > Created a defined UTM location for georeferencing > r.in.gdal (don't have the exact line written down, but it worked, I have > displayed the TIFF as a raster) > i.group group=map input=st...@permanent (assigned the one image to a group) > i.target group=...@permanent location=georeference mapset=permanent > (targeted the UTM location) > d.mon start=x0 (started the monitor) > Here's where it gets... not good. > i.points group=...@permanent (attempt to start identifying points) > and I get this: > Target information for group [map] missing > Please run i.target for group map > > Not really sure what's going on here... tried it multiple ways. Any > suggestions? Thanks! > > Joe > _______________________________________________ grass-user mailing list [email protected] http://lists.osgeo.org/mailman/listinfo/grass-user
