Hi Oompa, if you're projecting onto a plane rather than a surface, you're probably better off using the Project component in the XForm tab.
-- David Rutten Robert McNeel & Associates On Nov 25, 8:52 pm, oompa_l <[EMAIL PROTECTED]> wrote: > hi > > I have a series of non-planar curves that I would like to project to a > common planar curve. I can't figure out what's going wrong. I am using > the plane as the brep for projection and I see everything being > received right but no curves are coming out the other end... > > see planeprojection-screengrab.01.jpg > > I also started looking at drawing lines in the z direction to > intersect with the plane and then reconstruct the curve but I got > funny results for that too - the points weren't sitting on the plane - > and I couldnt see any logic behind where they did end up > > any ideas?
