Hey David,
Is there a reason that the output from a Loft component is a Brep?
Basically, I have some section curves that I'm lofting together, and
then I'd like to subdivide that surface by some interval. However,
when I feed the output of the lofted surface into a generic surface
parameter... it turns red. When I hover over the output from the Loft
component, it says "Open Brep" (which is why it's turning the surface
parameter red). The original curves that form the loft were created
through volatile data inheritance. The reason I bring that up, is
that I have another example, where I reference in 2 curves and then
feed those into a loft and the output reads "Untrimmed Surface". So,
why would the loft output a surface with referenced geometry, but a
brep with volatile data inheritance? I can't subdivide the Brep, so
is there a way to convert the open Brep back into a surface? Or is
this a bug?
Thanks,
Andy
