Hello, I'm new to grasshopper. I am working on a little project in the program but i have become stuck. I have a number of circles in grasshopper that are set up to enlarge and contract as they move away/towards a grid of points in front of them. The grid is positioned of the y,z plane. All the circles are positioned on the y,z plane and move towards/away from the grid along the x plane. I would like to create a surface between/around these circles, that is attached to the circles. So when i move one of the circles back or forth it will pull the surface with it and can deform it. Eg a flat surface, with the circles attached, which can be manipulated in different directions when the circles are be pushed and pulled I have tried lofting the circle, but this creates a tube like loft between them instead of a surface around them. I have also tried dividing the circles into point and trying to make a surface from these points, but again i couldn't achieve what i wanted. Are there any suggestions for how this might be done? Many thanks, Sonya
