Hi all,
I installed grml i386 via grml2hd onto my laptop that ran with grml 0.9
before. It is a IBM ThinkPad T23.
After booting from harddisk, I used grml-network to set up a static IP
address for the on-board eth card. Now I can access the laptop via ssh,
everything works fine.
Several hours later, my ssh connection is down, the laptop does not
respond to pings. I use the console and - much to my astonishment - the
static IP address was exchanged with an address from the DHCP range of
my router! I used grml-network again to enter the static IP address -
and next morning, it again was away and a dynamic IP address was used!
Well, since that first surprise this happens all few hours. I always
chose "enable at boot" at the last prompt.
What can I do do have my system remember the static IP address assigned
via grml-network instead of looking for a DHCP address?
Regards,
Werner
_______________________________________________
Grml mailing list - [email protected]
http://lists.mur.at/mailman/listinfo/grml
join #grml on irc.freenode.org
grml-devel-blog: http://grml.supersized.org/
