Dear Jastin Thanks very much for your reply, when I heat system from 0 to 300 K with simulated annealing, ref_t =300 is correct?
Best Regards On Tuesday, December 3, 2013 5:53 PM, Justin Lemkul <jalem...@vt.edu> wrote: On 12/3/13 2:17 AM, kiana moghaddam wrote: > Dear GMX Users > > I want to run NVT equilibration and NPT equilibration (after NVT) and want to > increase temperature gradually i.e. from 0 to 300 K over 100 ps, but I have > some questions about this process: > when I use simulated annealing in NVT as following > annealing_time = 0 15 30 45 60 80 100 > annealing_temp = 0 50 100 150 200 250 300 > I don't know how to change gen_temp. Should gen_temp be 0 or 300 K? > Generating velocities and then immediately freezing (in the strictest of sense) the system is likely not going to be stable or effective because the thermostat will go haywire trying to compensate for such a drastic change in temperature. It is an interesting question, because how does one generate velocities at 0 K? Theoretically, there are none. I would suggest setting gen_temp to 0; you can check the .tpr (via gmxdump) to see if any velocities are present, but even if they are they should be very small and largely irrelevant. The annealing protocol will warm the system relatively quickly, so even after a few dynamics steps, you will have small velocities within the system. > At the first time, I did not use simulated annealing. I prepared 7 mdp files > that in the first mdp file, I set nsteps=0, gen_temp=0, ref_t=0, then I use > the output from first NVT equilibration for the second input. I repeat this > to reach 300 K (in the second step nsteps=7500(*0.002=15), gen_temp=50, > ref_t=50). I 'm not sure whether this process is correct? Well, it works, but it's laborious and unnecessary because you're just manually doing what simulated annealing is doing. -Justin -- ================================================== Justin A. Lemkul, Ph.D. Postdoctoral Fellow Department of Pharmaceutical Sciences School of Pharmacy Health Sciences Facility II, Room 601 University of Maryland, Baltimore 20 Penn St. Baltimore, MD 21201 jalem...@outerbanks.umaryland.edu | (410) 706-7441 ================================================== -- Gromacs Users mailing list * Please search the archive at http://www.gromacs.org/Support/Mailing_Lists/GMX-Users_List before posting! * Can't post? Read http://www.gromacs.org/Support/Mailing_Lists * For (un)subscribe requests visit https://maillist.sys.kth.se/mailman/listinfo/gromacs.org_gmx-users or send a mail to gmx-users-requ...@gromacs.org.
