Hi, I have an existing sample plugin written for x86. I want to port the same for imx6 board. I have the tool chain and the header files on a builder machine where I generated the target image.
I was able to port my test appilcations without much trouble but the plugin configuration is proving to be a tough task. Is there any guide or link where the general steps for such task are listed. If not any suggestions to make porting more systematic. -- Regards, Subodh -- **************** CAUTION - Disclaimer ***************** This e-mail contains PRIVILEGED AND CONFIDENTIAL INFORMATION intended solely for the use of the addressee(s). If you are not the intended recipient, please notify the sender by e-mail and delete the original message. Further, you are not to copy, disclose, or distribute this e-mail or its contents to any other person and any such actions are unlawful. This e-mail may contain viruses. UFOMoviez India Ltd. has taken every reasonable precaution to minimize this risk, but is not liable for any damage you may sustain as a result of any virus in this e-mail. You should carry out your own virus checks before opening the e-mail or attachment. UFOMoviez India Ltd. reserves the right to monitor and review the content of all messages sent to or from this e-mail address. Messages sent to or from this e-mail address may be stored on the UFOMoviez India Ltd.'s e-mail system. ***************** End of Disclaimer ******************* _______________________________________________ gstreamer-embedded mailing list gstreamer-embedded@lists.freedesktop.org http://lists.freedesktop.org/mailman/listinfo/gstreamer-embedded
