In a message dated 7/24/01 8:20:37 PM Mountain Daylight Time, [EMAIL PROTECTED]
writes:
> . Does anyone out there have a method of loosening that
> bolt without removing hardware? I was able to adjust the chain anyway
> without too much fuss, but I would prefer to do it the right way if
> possible.
>
>
>
Chase;
It is a little difficult but not impossible. First you have to carry
a combination box end wrench which has the box end angeled slightly. I place
it onto the bolt head between the subframe support and the swing arm and
break the bolt loose then it is a matter of turning the bolt a little at a
time to loosen it enough to adjust the chain. The reverse the proceedure to
tighten. I carry two combination wrenches to hook one to the other to get
enough torque on the bolt. Hope this explanation is clear enough.
Bob
