Tom,
You will have to take it all apart, so grease it all. It has all been run the same
length of time on the previous lubrication job so if one is squeaking, the others are
not far behind. It is a bit of a challenge to get all the pivots off at one time and
pull the swing arm because the pipe and centerstand are in the way of removing the
bolts. I used two car jackstands to hold the bike under the frame while the
centerstand was removed. It worked well but takes two people to get it on the
jackstands safely. While you have them apart, inspect for wear on the collars and
bolts, including the main bolt used for the swing arm pivot. If you want a precursor
to what you might find, with the bike on the centerstand, grab the swingarm toward the
rear and lift. If you feel any movement that is slop, you need to find out where it is
coming from. Something is worn and you have undampened swing arm movement which causes
handling problems in certain situations.
Good luck.
RSRBOB
