Bonjour!
Je voulais essayer la "derni�re" de Lindows sur un "vieux" laptop (Thinkpad 600e) sur lequel est install� OS/2, mais j'obtiens le message suivant:
L 80 80 80 80 80 80 (etc...)
J'ai googl� pour comprendre ce que Lilo voulait me dire mais je n'ai rien trouv� de concret. Quelqu'un sait ce que cela signifie?
Touv� dans /usr/share/doc/lilo/Manual.txt.gz (Debian woody):
LILO start message - - - - - - - - - When LILO loads itself, it displays the word "LILO". Each letter is printed before or after performing some specific action. If LILO fails at some point, the letters printed so far can be used to identify the problem. This is described in more detail in the technical overview.
Note that some hex digits may be inserted after the first "L" if a transient disk problem occurs. Unless LILO stops at that point, generating an endless stream of error codes, such hex digits do not indicate a severe problem.
(<nothing>) No part of LILO has been loaded. LILO either isn't installed or the partition on which its boot sector is located isn't active. L <error> ... The first stage boot loader has been loaded and started, but it can't load the second stage boot loader. The two-digit error codes indicate the type of problem. (See also section "Disk error codes".) This condition usually indicates a media failure or a geometry mismatch (e.g. bad disk parameters, see section "Disk geometry"). LI The first stage boot loader was able to load the second stage boot loader, but has failed to execute it. This can either be caused by a geometry mismatch or by moving /boot/boot.b without running the map installer. LIL The second stage boot loader has been started, but it can't load the descriptor table from the map file. This is typically caused by a media failure or by a geometry mismatch. LIL? The second stage boot loader has been loaded at an incorrect address. This is typically caused by a subtle geometry mismatch or by moving /boot/boot.b without running the map installer. LIL- The descriptor table is corrupt. This can either be caused by a geometry mismatch or by moving /boot/map without running the map installer. LILO All parts of LILO have been successfully loaded.
Disk error codes - - - - - - - -
If the BIOS signals an error when LILO is trying to load a boot image, the respective error code is displayed. The following BIOS error codes are known: ... blabla 0x80 "Disk timeout". The disk or the drive isn't ready. Either the media is bad or the disk isn't spinning. If you're booting from a floppy, you might not have closed the drive door. Otherwise, trying to boot again might help.
Ca repond � votre question?
PM
-- Dr Pierre-O. Maitre Privat Docent FMH Anesth�siologie FMH Pharmacologie Clinique Cabinet m�dical / A la Joy CH-1273 Genolier Switzerland
_______________________________________________ gull mailing list [EMAIL PROTECTED] http://lists.alphanet.ch/mailman/listinfo/gull
