Don,
We just tried this here with a fresh install of 6.1, then installing the
7.0 beta, and were not able to duplicate the problem.
Aaron
Don H wrote:
After a install of the beta on my XP machine I had some strange problems
using my Dectalk Express. It turns out that for some reason my Braille
display selection went from none to the DM80 display selection on com 1
which is the same com port for my Dectalk. Changed the braille display
selection back to none and problem is resolved. Anyone else with this
problem?
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
--
To insure that you receive proper support, please include all past
correspondence (where applicable), and any relevant information
pertinent to your situation when submitting a problem report to the GW
Micro Technical Support Team.
Aaron Smith
GW Micro
Phone: 260/489-3671
Fax: 260/489-2608
WWW: http://www.gwmicro.com
FTP: ftp://ftp.gwmicro.com
Technical Support & Web Development
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
