Thanks. I'll mark these suggestions down.
Aaron
From: Christo de Klerk <[EMAIL PROTECTED]>
To: [email protected]
Subject: Skype script suggestions
Hi all
Perhaps the following suggestions could be considered for the Skype
scripts:
1. a hotkey to repeat the last announcement, such as whether a contact
has come online of gone offline.
2. Perhaps these announcements should interrupt rather than be
interrupted. I've found that if I'm reading or typing while contacts
come online or go offline, I don't get these notifications because
they get interrupted.
Otherwise the script is magic.
Regards
Christo
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo,
and can be searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body of the
message.
--
To insure that you receive proper support, please include all past
correspondence (where applicable), and any relevant information
pertinent to your situation when submitting a problem report to the GW
Micro Technical Support Team.
Aaron Smith
GW Micro
Phone: 260/489-3671
Fax: 260/489-2608
WWW: http://www.gwmicro.com
FTP: ftp://ftp.gwmicro.com
Technical Support & Web Development
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
