The object model in beta 2 doesn't allow for this, but we have made
aditions to it post 7.0 that would.
At 02:53 AM 8/15/2008, you wrote:
I should write this to the scripting list, but it is a good enough
idea to warrant some attention. Someone should write a very simple
script that would tell us the name of every single script running,
globally or to be potentially called, with the output going to a
read-only control so that it would be easier to keep a record of
what is running, to be called by hot key.
Then, when something goes wrong, we would' easier monitor what is
actually running or could run.
Curtis Delzer
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo,
and can be searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body of the message.
--
Michael D. Lawler
Voice 260-489-3671
Fax 260-489-2608
Internet mailto:[EMAIL PROTECTED]
web http://www.gwmicro.com
ftp ftp://ftp.gwmicro.com
GW Micro, Inc.,
Development Liaison and Technical Support Supervisor
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
