Braille does not travel via the virtual channel. It can work if you
bring the serial port data from the remote machine to the local one. So
perhaps you need to look at the serial port data setting.
Richard Bartholomew said the following on 9/9/2008 2:20 PM:
...and a question!
So far, I have not had any issues while running beta3 in a VDI session
with VMWare 6 and ESX servers and responsiveness is excellent when using
the virtual channel. One question, though...
I know this can be done as I've had it working with beta1 and, so, have
obviously not set something up properly this time but I cannot get my
PowerBraille 80 to work in the VDI session; it's working perfectly well
in the local environment, though.
Any suggestions greatly appreciated and good work, GW, in getting this
environment to work well - hope I haven't tempted fate too much ;-)
Regards
Richard Bartholomew
E-Mail: [EMAIL PROTECTED]
<mailto:[EMAIL PROTECTED]>
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
--
Raul A. Gallegos -- GW Micro Technical Support
Voice: 260-489-3671 -- Fax: 260-489-2608
WEB: http://www.gwmicro.com
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
