Yes I had this problem and called GW Micro earlier today and discussed it.
I needed to get into Windows Explorer instead of the setup dialogue. To do
that I opened up to the drive that contained the CD. In my case this is the
d-drive. I did not press enter to go into it, but instead I pressed the
context key to go to Explorer. I pressed enter on that choice. Next I went
to the folder containing the tutorial. Last I selected a document and
entered and the tutorial began. I am hoping I am recalling the steps
correctly from this morning. Anyone else is welcome to correct this if
needed.
Barbara Sheinbein
----- Original Message -----
From: "John Glass" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Friday, September 26, 2008 8:54 PM
Subject: Can't Get The Version 7.0 Tutorial to Play
Hello,
I can't get the tutorial to play in my Plextalk.
When I insert the disk in my computer, and try to play the tutorial,
Winamp loads, but nothing plays.
Is anyone else having this problem?
John
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and
can be searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body of the message.
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
