I have seen this too.
Jeff Weiss
-----Original Message-----
From: Chris Skarstad [mailto:[EMAIL PROTECTED]
Sent: Monday, October 06, 2008 11:00 AM
To: [email protected]
Subject: weirdnes with Install Packages 3.7
Hey folks
I did a check to see if there were any scripts just a bit ago using
Intstall Packages 3.7. I have mine set to show updates only, because
it's just so easy to go down the list if there is one and install
them. There was a new version of a script so I installed it, and
all worked just fine. but the weird part is, after the package was
installed, the same one I just installed showed up in the list
again. Usually what's supposed to happen is that if there aren't any
scripts available, it'll say, no items! I've seen this happen a few
other times and didn't think much of it, but I'm wondering if anyone
else has seen this?
I would think that if a new package was installed that the same one
wouldn't show up again?
Not sure what to think of this one.
Thanks.
Chris
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and
can be searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
