Hi. the actual version number is 7.01 not 7.1. If you go to help/about,
you should see 7.01. Wednesday October 23, 2008. If you do not, it's
possible your upgrade to 7.01 was not successful.
Many thanks.
jerry doody said the following on 10/25/2008 8:28 PM:
hi all,
I have, I think, successfully installed we7.1. I am not sure why the
upgrade doesn’t change the number in the window-eyes control pannel in
the readme or about files. any help would be appreciated. I am running
serv. pac. 3 xp. also, when I lost speech in outlook 2003, I ran my
rules again and it seemed to fix itself. I also went to micro soft and
repaired my office. Hope this helps those of you who are having the
loss of speech in th email thing. In general, though, I find this new
upgrade serve me very well.
Jerry Doody
email: [EMAIL PROTECTED]
Phone: (860)649-7920
Cell: (860)490-0508
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
--
Raul A. Gallegos -- GW Micro Technical Support
Voice: 260-489-3671 -- Fax: 260-489-2608
WEB: http://www.gwmicro.com
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.