Hello. You should write the script author to see if this is an issue he
can address.
Michael C. Capelle said the following on 11/10/2008 3:49 AM:
hello gw list
after updating my homer shared object library to 5.0, once you load we,
you have to wait about 10-seconds before you can start using your system.
if i turn off scripts, this does not happen, once again, this happened
after installing homer shared object 5.0.
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and
can be searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body of the message.
--
Raul A. Gallegos -- GW Micro Technical Support
Voice: 260-489-3671 -- Fax: 260-489-2608
WEB: http://www.gwmicro.com
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
