Hmmm. I don't think as far as the script goes there is a difference. Try
removing and re-installing the script.
Jeff
----- Original Message -----
From: "Kim Lingo" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Thursday, November 20, 2008 11:38 AM
Subject: Winamp script
I recently upgraded to the Winamp Pro version. I installed it over the
freeware version. Everything seemed to be okay, but then I wondered if I
should have removed the earlier version before installing the new one. I
there did that and re-installed the version I bought. Since then, I
haven't been able to get the script to work, and I am under the impression
that it might not be showing that I bought their enhanced version which
allows for CD burning and ripping. Is there a trick to getting the script
to work? Is it necessary to install it first?
I realize I shouldn't expect any real info about Winamp here, but perhaps
some info about the script?
Kim Lingo
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and
can be searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body of the message.
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and
your message is related to GW Micro, then please consider sending
your message to [email protected] so the entire list will receive it.
All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be
searched through and sorted using the search
form at the bottom of the page.
If you wish to unsubscribe from this list, send a message to
[EMAIL PROTECTED] and include leave gw-info in the body
of the message.
