as for the outlook read/unread, there's an article on the GW knowledgebase, explaining the steps needed sometimes to make this work.
I am working on a script to replace this system, but it will be a while until it's ready. Chip -----Original Message----- From: Edward [mailto:[email protected]] Sent: Sunday, June 14, 2009 1:50 AM To: [email protected] Subject: Reading read and unread Hello all Windoweyes is not reading read and unread in outlook03. is there a way to fix this? Also is there a way to get windoweyes to say tab after hitting the tab key globally? Thanks Edward If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be searched through and sorted using the search form at the bottom of the page. If you wish to unsubscribe from this list, send a message to [email protected] and include leave gw-info in the body of the message. If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. All GW-Info messages are archived at http://www.gwmicro.com/gwinfo, and can be searched through and sorted using the search form at the bottom of the page. If you wish to unsubscribe from this list, send a message to [email protected] and include leave gw-info in the body of the message.
