Thanks to everyone who offered suggestions, when I was trying to
activate links on a particular
website. I had copied the link for the page from an e-mail, and failed to
notice that it
was followed by a period. The site still loaded, but the links didn't work.
Once the unwanted punctuation was removed, everything
worked properly. I thought I'd mention this, in case someone else runs into
a similar situation.
Regards,
Paula
----- Original Message -----
From: <[email protected]>
To: <[email protected]>
Sent: Monday, March 14, 2011 8:27 AM
Subject: RE: Routing the Mouse to a Link
Hi Paula
I find it is much more accurate if I route the mouse pointer to the link
when out of browse mode. You can also try insert+tab while you are on
the link then tab to the activate link button. sometimes this also
works.
Vic
If you reply to this message it will be delivered to the original sender
only. If your reply would benefit others on the list and your message is
related to GW Micro, then please consider sending your message to
[email protected] so the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can
manage your list subscription at http://www.gwmicro.com/listserv.
If you reply to this message it will be delivered to the original sender only.
If your reply would benefit others on the list and your message is related to
GW Micro, then please consider sending your message to [email protected] so
the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage
your list subscription at http://www.gwmicro.com/listserv.
