Carol and/or Roger,
If you get a private answer about increasing the mike boost, please forward
it to me. I have a sound blaster as well, different version, but a similar
problem with a particular application.
----- Original Message -----
From: "Carol and Roger" <[email protected]>
To: "Stephen Clower" <[email protected]>; <[email protected]>
Sent: Tuesday, April 05, 2011 7:39 AM
Subject: Re: Eloquence and Dectalk software Synthasizers
I am running Windows7 Home Premium with a Dell desktop. I have followed
the steps in the article, but I do not have an enhanced pane. Does this
mean anything? My sound card is a SoundBlaster X Fi Streme. That may not
be written correctly, but that is the way it is pronounced.. Also, since
we are talking about sound cards, I also don't seem to have the setting
for boosting microphone levels. Do you have any ideas about how I can get
my mic level increased? When I log in to the webinars, I am told I can be
heard, but my volume is very low. My level is set to 100% and I have the
mic about one-half to one inch away from my mouth. I don't like being
that close as I am afraid I will bump the mic. Any suggestions would be
helpful. Thanks.
Carol
On 4/5/2011 8:14 AM, Stephen Clower wrote:
Jim,
Ensure audio enhancements are disabled for your sound card. You can learn
more on how to do this at http://www.gwmicro.com/kb1121.
Regards,
Steve
On 4/4/2011 8:43 PM, Jim in Detroit (James A. Prather) wrote:
Why, when I switch synthasizers, does Window-Eyes 7.5 not speak readily?
The last two times I had to restart my machine. I’m using a laptop with
Windows 7, Home Premium 64-bit machine. Thanks. Jim in Detroit
If you reply to this message it will be delivered to the original sender
only. If your reply would benefit others on the list and your message is
related to GW Micro, then please consider sending your message to
[email protected] so the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can
manage your list subscription at http://www.gwmicro.com/listserv.
If you reply to this message it will be delivered to the original sender only.
If your reply would benefit others on the list and your message is related to
GW Micro, then please consider sending your message to [email protected] so
the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage
your list subscription at http://www.gwmicro.com/listserv.
