Actually, that's a part of the program that works very much like before. Go to the File menu, just as before, then arrow down to an item that's now titled Factory Settings. There's also an Update Settings item, but the Factory Settings item will work fine.
Richard Petty ILRU - Independent Living Research Utilization [email protected] (E-Mail) -----Original Message----- From: Robert Ringwald [mailto:[email protected]] Sent: Thursday, May 05, 2011 1:52 AM To: GWMicro List Subject: Question, Set Files and How To Find Them? I can't figure out how to use the new WE panel effectively. I have searched and searched and cannot find the place to update the set files. Where in the Blank is it? --Bob Ringwald www.ringwald.com Fulton Street Jazz Band 530/ 642-9551 Office 916/ 806-9551 Cell Amateur (Ham) Radio K6YBV Paddy says "Mick, I'm thinking of buying a German Shepherd." "Are you crazy," says Mick, "Have you seen how many of their owners go blind?" If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage your list subscription at http://www.gwmicro.com/listserv. If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage your list subscription at http://www.gwmicro.com/listserv.
