Good morning, I have a spread sheet that I want to hear the some of the column. I used to use control insert S to get this in excel 2000. Now that I have 2010 I hear way more than I want. I hear the average, count cell mode ready current cell amount normal page layout, zoom in zoom out and bla bla and eventually the sum.
What is the best way to just hear the sum? Do I have to some how define a window on this area to just hear that part? or is there a way in excel to turn off all the stuff at the bottom. I don't know how to use the monitor cells and this is one of those spread sheets that changes every time I run this report. So I think I would have to set up a total sell each and every time I did. Any suggestions? Oh, I just thought of another question. Is there a way using the key board to make the cell area of the work sheet fill the screen? I have the Excel window maximized but the work sheet is not filling the excel window. I know if I physically can get the mouse to the bottom right corner and pull it down and to the right the cells will fill the screen but that is not real easy to do. Just thought one of you may know how to make the work sheet maximized not just the excel window. Thanks Shannon If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage your list subscription at http://www.gwmicro.com/listserv.
