Open the Window-Eyes control panel. Under the Dictionaries node go to
the Status branch, tab down, and make sure key label dictionaries is on.
The global KeyLab.key dictionary contains just these basic command (key)
labels.
Hth,
Tom
On 12/27/2011 5:32 PM, Dave bahr wrote:
Hi list,
sorry for the nebulous subject line, but I'm having an issue here with
the keyboard. It used to be that when I pressed control c to copy, we
would say, copied to clipboard. Same with cut, paste, things like that.
Now it's just saying c, x, and v, respectively. I've gone through the
menus and all that I can think of, but how do I Get we to say those
little commands again? There must be some setting that I just can't
think of. Make Sense? Any help is greatly appreciated.
If you reply to this message it will be delivered to the original sender only.
If your reply would benefit others on the list and your message is related to
GW Micro, then please consider sending your message to [email protected] so
the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage
your list subscription at http://www.gwmicro.com/listserv.
