Robert,
Just to clarify, you can still set the parameters for speech
synthesizers. Most Braille displays which support serial communication
never allowed you to adjust their settings, and thus their default
parameters are used or, in the case of displays which can be configured,
the fastest settings are used.
HTH,
Steve
On 5/22/2012 5:03 PM, Rob Hudson wrote:
Ok, it was puzzling me because you used to be able to set those
parameters. I got it working now though.
----- Original Message ----- From: "Stephen Clower" <[email protected]>
To: "Rob Hudson" <[email protected]>
Cc: <[email protected]>
Sent: Tuesday, May 22, 2012 3:03 PM
Subject: Re: communications parameters in window-eyes
Robert,
Serial parameters are located in the devices section of the WE control
panel (assuming advanced options are enabled). In terms of Braille
displays, individual communication parameters cannot be adjusted.
Rather, Window-Eyes uses whatever the defaults happen to be per
display; e.g. most units use 9600 BAUD, 8 data bits, no stop bits, and
hardware flow control.
Regards,
Steve
On 5/22/2012 4:00 PM, Rob Hudson wrote:
Where are the settings like baud rate and stuff when selecting a
braille display over com1? Window eyes 7.5.4.
If you reply to this message it will be delivered to the original
sender only. If your reply would benefit others on the list and your
message is related to GW Micro, then please consider sending your
message to [email protected] so the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You
can manage your list subscription at http://www.gwmicro.com/listserv.
--
Stephen Clower
Product support specialist & App Development
GW Micro, Inc. * 725 Airport North Office Park, Fort Wayne, IN 46825
260-489-3671 * gwmicro.com
If you reply to this message it will be delivered to the original sender
only. If your reply would benefit others on the list and your message is
related to GW Micro, then please consider sending your message to
[email protected] so the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can
manage your list subscription at http://www.gwmicro.com/listserv.
--
Stephen Clower
Product support specialist & App Development
GW Micro, Inc. * 725 Airport North Office Park, Fort Wayne, IN 46825
260-489-3671 * gwmicro.com
If you reply to this message it will be delivered to the original sender only.
If your reply would benefit others on the list and your message is related to
GW Micro, then please consider sending your message to [email protected] so
the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage
your list subscription at http://www.gwmicro.com/listserv.
