Chip,
While Eloquence is active, open the WE control panel and navigate to
Devices/Synthesizers. From there you can explicitly define which audio
device Eloquence should use. Click the Activate button when you are
finished to apply the change.
Regards,
Steve
On 5/31/2012 10:29 PM, Chip McCain wrote:
A large part of my work on the PC is audio recording. I have an audio
interface to record with, but when i turn it on Eloquence quits speaking and I
have to shut down Windoweyes and reload it. Is there not a way to make
Eloquence, or any synthesizer for that matter, to stay loaded and not try to
switch to the new audio device?
If you reply to this message it will be delivered to the original sender only.
If your reply would benefit others on the list and your message is related to
GW Micro, then please consider sending your message to [email protected] so
the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage
your list subscription at http://www.gwmicro.com/listserv.
--
Stephen Clower
Product support specialist & App Development
GW Micro, Inc. * 725 Airport North Office Park, Fort Wayne, IN 46825
260-489-3671 * gwmicro.com
If you reply to this message it will be delivered to the original sender only.
If your reply would benefit others on the list and your message is related to
GW Micro, then please consider sending your message to [email protected] so
the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage
your list subscription at http://www.gwmicro.com/listserv.
