Hey bill,
I was having some issues with read to end, and some one suggested
renaming the hot key to control shift enter, which fixed the problem.
Give it a try.
Warm regards Manny
Good luck, Manny checkout my stand-up comedy performance
http://www.youtube.com/watch?v=75fbevlz10g computer specifications:
Window Eyes 8 Dell xps420 with 8 gb memory c p u: Intel q6600 quad core
dual boot between Windows 7 64-bit and windows 8 64 bit all software and
drivers are up to date
On 2/20/2013 1:21 PM, Bill Holton wrote:
I am not using the new page. I am using the Shift-Ctrl-r read to end
hotkey. I actually have the new page set to read nothing, I usually then
press the read to end hotkey to start the reading once I cursor past the
annoying stuff.
BILL HOLTON
Email: [email protected]
P: 386-624-6309 C: 386-624-3255
Home Office: 1520 Loughton ST
DeLand, FL 32720
-----Original Message-----
From: net bat [mailto:[email protected]]
Sent: Wednesday, February 20, 2013 6:05 PM
To: [email protected]
Subject: Re: Read to end problem with 8.1, anyone elase having this problem?
look in verbocity/browse mode/new page information and change it to read
entire page. the factory default is to only read the first 24 lines.
-----Original Message-----
From: Bill Holton
Sent: Wednesday, February 20, 2013 2:59 PM
To: [email protected]
Subject: Read to end problem with 8.1, anyone elase having this problem?
Hi.
When I try to do a read to end with WE 8.1 WE reads to the end of the
screen, then stops, and the cursor is still at the beginning. I have had
this problem in IE and in Outlook, which uses the IE engine, I believe.
BILL HOLTON
Email: [email protected]
P: 386-624-6309 C: 386-624-3255
Home Office: 1520 Loughton ST
DeLand, FL 32720
If you reply to this message it will be delivered to the original sender only.
If your reply would benefit others on the list and your message is related to
GW Micro, then please consider sending your message to [email protected] so
the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage
your list subscription at http://www.gwmicro.com/listserv.
If you reply to this message it will be delivered to the original sender only.
If your reply would benefit others on the list and your message is related to
GW Micro, then please consider sending your message to [email protected] so
the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage
your list subscription at http://www.gwmicro.com/listserv.
