Bob, See below some tips. Your question is also answered.
To configure Becky for use with Window-eyes do the following: Go to the Tools menu and select "General Setup." Then select the message view tab. Make sure the "operate four way button by the cursor key option is unchecked. The next item you would want to change is to remove the pointer. If you fail to do this the first character of each line will be cut off. 1. Go to the tools menu and select General setup. 2. Select the editor tab. 3. Press ALT-Y to move to the "display line pointer" check box and uncheck it. Here is a tip to display the CC and BCC fields in tab order. 1. Write a new message. 2. In the TO: field press CONTROL down arrow once, this enables the CC field. Press it again to enable the BCC field. If you decide you use the CC field but not the BCC field, just press CONTROL up arrow this will remove the BCC field from the tab order. To remove the CC field from the tab order press CONTROL up arrow again. Regards, Marten The state of the CC and BCC fields in the tab order is saved between sessions. On Sun, 03 Mar 2013 14:56:47 -0500 bob jutzi <[email protected]> wrote: > Nno RSS support in Becky Email? > > I finally decided to have a look. The UI is extremely easy; however, > hhow do you get Window-eyes to review a message since using the arrows > ddoesn't appear to do anything. Is Read-to-end the only means of > aaccomplishing this? > > > If you reply to this message it will be delivered to the original sender > only. If your reply would benefit others on the list and your message is > related to GW Micro, then please consider sending your message to > [email protected] so the entire list will receive it. > > GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can > manage your list subscription at http://www.gwmicro.com/listserv. If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage your list subscription at http://www.gwmicro.com/listserv.
