Bud, What program are you using when this happens to you?
Chip -----Original Message----- From: Bud Schwab [mailto:[email protected]] Sent: Saturday, September 07, 2013 1:48 PM To: [email protected] Subject: not reading all lines Hi Gang, Wonder if anybody else has this problem. Often if I press the down arrow I just get nothing line after line. Finally I start up arrowing and it reads the lines that were silent before. Any ideas as to what causes this. I never know when there are silent lines whether they really have no text or if it is just passing over them silently. Am using we 8.3 and windows 7 64 bit. I believe this situation has been ongoing for some time now so don't know just what version I was using when it started. Thanks for any ideas. Bud Schwab W 6 Z Y P Malibu, California If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage your list subscription at http://www.gwmicro.com/listserv. If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it. GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage your list subscription at http://www.gwmicro.com/listserv.
