Hi,
First, as you probably know, the brailliant displays use a virtual serial
port. Before you set it up in Window-Eyes, you will need to go into control
panel and system to and device manager to see which port is being assigned.
Next, go into hardware and braille display in the W.E. control panel.
Select the port. Then, in the list of braille displays, scroll down to the
Humanware Brailliant BI. Then, finally, click on activate.
Hope this helps..
Warm Regards.. Joe Lanier
-----Original Message-----
From: Bill Belew [mailto:[email protected]]
Sent: Wednesday, February 12, 2014 12:04 PM
To: 'Matthew Bullis'
Cc: [email protected]
Subject: RE: Will WindowEyes work with the Humanware Brailliant display?
Hello,
I am currently using a HumanWare Brailliant BI 40 display with Window-Eyes.
There are no additional drivers needed to use it with Window-Eyes, but there
are additional Jaws drivers on your disk.
From: Matthew Bullis [mailto:[email protected]]
Sent: Wednesday, February 12, 2014 7:59 AM
To: GW Micro Product Discussion Listserv
Subject: Will WindowEyes work with the Humanware Brailliant display?
Hello, I don't see the Brailliant display in the list of possible devices to
add, and the disc that comes with the display doesn't have any specific
drivers. Will this particular display work? It's the Brailliant BI40.
Thanks,
Matthew
If you reply to this message it will be delivered to the original sender only.
If your reply would benefit others on the list and your message is related to
GW Micro, then please consider sending your message to [email protected] so
the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage
your list subscription at http://www.gwmicro.com/listserv.
