Hi Don,
A case like that for the voice sense and syncbraille would be very nice.
Yes, it would make th etwo bigger and less compact but maybe it would all be more secure.

Have a blessed day,
Stacey Robinson and GEB dog Chesley
Eagleville, Tennessee.
[email protected]
You can also write me at
[email protected]

Check out my website and blog at
www.samobile.net/users/staceylr

----- Original Message ----- From: "don bishop" <[email protected]>
To: <[email protected]>
Sent: Sunday, March 29, 2009 4:41 PM
Subject: Re: [GWN] CAse issue seems to be resolved


Yes, you have to have the vs positioned just right against the two front posts and then press the middle of the back of the vs down somewhat firmly and then it should snap into place. It can be a bit tricky until you get the hang of it, and it's easy to assume you have it in place when it really isn't quite snapped into position. If you get it snapped in, I really don't think you should have any further trouble with it.


While on the subject of cases, as I mentioned the other day, we just purchased and received a new braillesense.

The case on that is really nice. It's padded and has velcro flaps which will close off all openings such as ports etc., and the case closes with a flap on the front closing with velcro. There is also velcro along the sides of the case so when you close it, not only is velcro holding it shut from the front, but on the sides as well.

It really protects the machine and is the best case I've seen so far. Much better than the MPower case and easier to close tightly as well.

Nice job gw!

Don


----- Original Message ----- From: "Stacey Robinson" <[email protected]>
To: <[email protected]>
Sent: Sunday, March 29, 2009 2:13 PM
Subject: [GWN] CAse issue seems to be resolved


Hi all,
I had my husband look at my vs case after reading Don's last message. I thought maybe one of the medal pieces might have been bent. I put it back in the case and there was a deffinit snap. I can't pop it out with one hand now. This is deffinitly a good thing. I would still like to see a more secure design. Maybe a case sort of like a braille note case. The sync braille could stay where it is and there could be some sort of slot to slied the vs into. There could be a section that would go over the keys with cutouts for the keys and the buttons on the front could still be exposed.
I don't know, I'm just thinking as I type.

Have a blessed day,
Stacey Robinson and GEB dog Chesley
Eagleville, Tennessee.
[email protected]
You can also write me at
[email protected]

Check out my website and blog at
www.samobile.net/users/staceylr


__________ NOD32 3973 (20090329) Information __________

This message was checked by NOD32 antivirus system.
http://www.eset.com




Reply via email to