Hi!
The fix was simple and only took a few seconds to make the change; but
had to walk my dog before testing and get my network up of course.
Below is the fix by expanding that error line into 2 lines and instead
of moving, copying and over-writing if they exist. Then deleting the initial
files after copying them over.
This is error was there all along, just never did a new package update
or the error would have been discovered, but my computer died back on August
4 and just got back yesterday; do the math...
The error fix:
fso.CopyFile clientPathToWav & "Cluck" & CStr(i) & ".clk",
clientPathToWav & "CuckooRecordAndPlayWav\" & File, TRUE
fso.DeleteFile clientPathToWav & "Cluck" & CStr(i) & ".clk"
My upgrade tonight will be version 3.1 for this issue. Will package and
upload in a few minutes.
Sincerely
Bruce
Sent: Friday, September 30, 2011 9:17 AM
Subject: Re: Cuckoo Clock Error!
Hi Again,
For the time while I fix this issue since I have a friend over to get
my computer network up and running, the fix is to ignore the error and hit
the ignore button and it will work fine.
this error was not there when using it last month, so I may have
packaged the wrong file. I hope to have the fix as quick as I can.
Sorry about that.
Bruce
Sent: Friday, September 30, 2011 9:11 AM
Subject: Cuckoo Clock Error!
Hi!
Sorry about the error, I will have to add a resume next, but when
uploading I had just got my computer back and did not test the only file
I had with this update and the error was not there before my computer
died, so I may have the wrong revision.
The error is not a bad one but an annoying one. For it is moving files
to the sub directory, but those who have that directory those files
already exist.
So, I have 2 sub routines doing the same thing and will have to look
and see if this was just the test routine and will upload the fix.
Bruce
