I noticed a difference when using the radio for frequency coordination from 450 - 700 MHZ.
The install was simple. However, taking the OEM case apart is a pain. I ended up making my case much less pretty due to marks where I pryied it open. Also take care on the solder, there are a few components close to where the shield goes. I am going to switch to a metal case once something like the ham-it-up one becomes available. -- dhh On 9/15/2014 10:45, Stefan Wagener wrote: > .... and on a similar note, is there another case available that gives > access to the pin headers and might be even transparent. Anyone having a 3D > printer and can make some? > > Stefan > > On Mon, Sep 15, 2014 at 7:13 AM, C Crane <ccrane...@gmail.com> wrote: > >> Apologies if this has been asked already but I purchased the internal >> shielding and header jumper kit from nooelectric while waiting for the >> HackRF to arrive. Is this kit still even necessary (shielding parts)? If >> it's worth the effort of installing how does the plastic case come apart? >> Does it snap together or are there screws under the corner feet? >> >> Thanks, >> >> Casey >> >> _______________________________________________ >> HackRF-dev mailing list >> HackRF-dev@greatscottgadgets.com >> http://nine.pairlist.net/mailman/listinfo/hackrf-dev >> >> > > > > _______________________________________________ > HackRF-dev mailing list > HackRF-dev@greatscottgadgets.com > http://nine.pairlist.net/mailman/listinfo/hackrf-dev > _______________________________________________ HackRF-dev mailing list HackRF-dev@greatscottgadgets.com http://nine.pairlist.net/mailman/listinfo/hackrf-dev
