Thanks, I will try that. Cheers, Frank
On Fri, Apr 17, 2015 at 5:37 PM, Rick "Zero_Chaos" Farina < [email protected]> wrote: > My tx and rx amps have both been blown for I don't exactly know how > long. Even still, I'm able to receive tons of signals with no problems, > I even used it to hack a wireless security system (no not just listening > to commercial FM and high power repeaters). > > I don't think blowing the rx amp would cause it to see nothing, but it's > possible that the other gain settings are bad for lack of an rx amp. I > almost always run gqrx with the "-r" flag which resets all settings at > startup and that leaves me with a sane and working system as I switch > hardware often. > > -Zero_Chaos > > On 04/16/2015 04:45 AM, Dominic Spill wrote: > > Hi Frank, > > > > On 15 April 2015 at 20:56, Frank Pedersen <[email protected]> wrote: > >> > >> There was a guy that send out an rf signal on 0,5 w like 1 meter away > from me > > > >> Anyone have any idea what can have happened and what I can do to > >> troubleshoot? Is it the radio rx part that was burned perhaps? > > > > It sounds like the RX amplifier may have been damaged by that signal. > > > > Could you try running your hackrf_transfer -r command again with the > > RX amp explicitly disabled? Then with it explicitly enabled? Do you > > see any difference in the output? > > > > Thanks, > > Dominic > > _______________________________________________ > > HackRF-dev mailing list > > [email protected] > > https://pairlist9.pair.net/mailman/listinfo/hackrf-dev > > > > > > _______________________________________________ > HackRF-dev mailing list > [email protected] > https://pairlist9.pair.net/mailman/listinfo/hackrf-dev > >
_______________________________________________ HackRF-dev mailing list [email protected] https://pairlist9.pair.net/mailman/listinfo/hackrf-dev
