Hi all, Got to lesson 5 in the tutorial and I think I broke something after upgrading to hackrf-2015.07.2 (firmware and cpld images) . I can only capture 1kB using 'hackrf_transfer -r'. Help me understand if I'm doing something wrong.
""" $ hackrf_info Found HackRF board 0: USB descriptor string: 0000000000000000406464c8234b984b Board ID Number: 2 (HackRF One) Firmware Version: 2015.07.2 Part ID Number: 0xa000cb3c 0x006a4f56 Serial Number: 0x00000000 0x00000000 0x406464c8 0x234b984b $ hackrf_transfer -r rx.raw call hackrf_sample_rate_set(10000000 Hz/10.000 MHz) call hackrf_baseband_filter_bandwidth_set(9000000 Hz/9.000 MHz) call hackrf_set_freq(900000000 Hz/900.000 MHz) Stop with Ctrl-C 19.9 MiB / 1.000 sec = 19.9 MiB/second 19.9 MiB / 1.000 sec = 19.9 MiB/second 19.9 MiB / 1.000 sec = 19.9 MiB/second ^CCaught signal 2 4.7 MiB / 0.224 sec = 21.1 MiB/second User cancel, exiting... Total time: 3.22409 s hackrf_stop_rx() done hackrf_close() done hackrf_exit() done fclose(fd) done exit $ hexdump rx.raw | head -10 0000000 ff00 ffff ff00 ff00 ff00 ff00 0000 ff00 0000010 ff00 ff00 ff00 ff00 0000 ffff ff00 ffff 0000020 fe00 ff00 ff00 ff00 ff00 ff00 ffff ff00 0000030 ffff ff00 ff00 ff00 ff00 0000 ff00 0000 0000040 ff00 ff00 fe00 ff00 ff00 ff00 ff00 ff00 0000050 ff00 ff00 ff00 ff00 fe00 ff00 ff00 fe00 0000060 0000 ff00 ff00 ff00 ff00 ff00 ff00 ff00 0000070 ff00 ff00 ff00 ff00 ff00 fe00 ff00 ff00 0000080 ff00 ff00 ff00 0000 ff00 ff00 ff00 ff00 0000090 ffff ff00 ff00 ff00 ffff ff00 ff00 ff00 ... """ In the above rf capture not even the first 1KB looks valid. Tried reverting to fw/cpld image 2014.08.1 but the behaviour is the same, however cannot say for sure that if 'hackrf_transfer -r' captured valid data before upgrade. The FM radio build in lesson one works as expected as does osmocom_fft. Best, Brent _______________________________________________ HackRF-dev mailing list [email protected] https://pairlist9.pair.net/mailman/listinfo/hackrf-dev
