Hi Alf, I have a 2.4 kHz crystal filter in my AR7030, which is Kenwood's equivalent to the FL44A. The large case size and pin-arrangement appears identical to the FL44A which I used to have installed in a NRD-525 years ago.
I did not need to use any capacitors, inductors or other matching components with this filter, just small-diameter coaxial cable for input/output leads. I mounted the filter to a nearby shielding "can" with sticky-back back foam tape. Keep the coax leads as short as possible to reduce the chance of signal leakage. This filter works very well for me, and is noticeably better than the stock 2.2 kHz ceramic in the AR7030. best DX, Guy Atkins [EMAIL PROTECTED] Bonney Lake, WA USA -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Alf Ardal Sent: Friday, October 04, 2002 4:53 PM To: HCDX Mail Subject: [HCDX] Filters in AR 7030? I wonder if any have installed a Icom FL44A filter in their AOR 7030? Is there needed a change of components when installing one? 73's Alf Aardal ---[Start Commercial]--------------------- Check out new HCDX web site: http://www.hard-core-dx.com/ ---[End Commercial]----------------------- ________________________________________ Hard-Core-DX mailing list [EMAIL PROTECTED] http://www2.hard-core-dx.com/mailman/listinfo/hard-core-dx http://www.hard-core-dx.com/ _______________________________________________ THE INFORMATION IN THIS ARTICLE IS FREE. It may be copied, distributed and/or modified under the conditions set down in the Design Science License published by Michael Stutz at http://dsl.org/copyleft/dsl.txt
