I have been trying to find RG-174U cable to rebuild the AL4 Drake Loop. All I can find is RG-176/U. The difference I can find is the RG-174U runs 50 ohms and the RG-176/U runs 75 ohms. Apparently the input of the SPR4 runs 50 ohms where the loop plugs in. Do you think using 75 ohm cable would make any difference? If we are talking about 300 ohms and going to 325 ohms, it probably would make little difference, but going to 75 ohms in doubling it from 50. Any thoughts or should I try to find RG-174U? Thanks.
73s, Patrick Patrick Martin Seaside OR KAVT Reception Manager ---[Start Commercial]--------------------- World Radio TV Handbook 2005 is coming out. Preorder yours and support open communications for DXers: http://www.amazon.com/exec/obidos/ASIN/0823077942/hardcoredxcom ---[End Commercial]----------------------- ________________________________________ Hard-Core-DX mailing list [email protected] http://dallas.hard-core-dx.com/mailman/listinfo/hard-core-dx http://www.hard-core-dx.com/ _______________________________________________ THE INFORMATION IN THIS ARTICLE IS FREE. It may be copied, distributed and/or modified under the conditions set down in the Design Science License published by Michael Stutz at http://dsl.org/copyleft/dsl.txt
