Hello Hardware List,
I have to put a network in place. It's about 700 ft from the
start to where I need to end it. It's got to be copper. I was going
to run Cat6 (Cat6e?) even though its a 10/100 network and drop a
10/100 switch every 200 ft or so. The switch would serve 2 purposes: 1>
allow an access point and 2> let me run the network without losing
the signal strength. Is this doable? Comments?
--
Regards,
joeuser - Still looking for the 'any' key...
"...now these points of data make a beautiful line..."
